Phone: 01 458 7932
Email: info@advancedengineering.ie
The banner arm is fixed at the top of the flagpole. The arm is mounted on a very durable Teflon bearing set and can rotate 360 degrees. A flag weight is fitted to the bottom edge of the flag. Tall flags can be fitted with rings to keep them tight to the pole along the entire length. The standard banner arm lengths are 120cm (4-8m Flagpoles) and 150cm (for 9-12m flagpoles) but arms can naturally be built to order.
For 4-18 metre flagpoles. The most popular method for fixing ground mounted flagpoles. Anchor bolts are set into concrete foundation and fixed to a two plate hinging system at the bottom ot the flagpole. This makes ut easy to raise, lower and align the flagpole after the base is installed. All fittings are manufactured from galvanised steel.
For extra halyard security you have to open a lockable cover in the flagpole itself. The halyard can be pulled out and the flag raised and lowered manually. 
The halyard can then be fed into the flagpole again and the cover locked. A flag wieght is fitted to the bottom edge of the flag. The system can be used for flagpoles measuring up to 12 metres.
The halyard can then be fed into the flagpole again and the cover locked. A flag wieght is fitted to the bottom edge of the flag. The system can be used for flagpoles measuring up to 12 metres.
For use with 6-10 metre flagpoles. At the bottom a bracket is mounted with a base plate for the hinged fittings. At the top (approx 200cm above the bracket) a
wall fitting is mounted with angle fittings and clamps that are tightened around the flagpole. A butt with pivot fittings is cast into the flagpole. Both the fittings and clamps are hot galvanised.
wall fitting is mounted with angle fittings and clamps that are tightened around the flagpole. A butt with pivot fittings is cast into the flagpole. Both the fittings and clamps are hot galvanised.
For use with a 2-6 metre flagpole. The bracket is firmly affixed to the facade, a butt for fitting into the bracket is cast into the flagpole.
The flagpole is secured to the bracket with a bolt. Both bracket and butt are hot galvanised.
The flagpole is secured to the bracket with a bolt. Both bracket and butt are hot galvanised.
For use with 3-6 metre flagpole. Two sets of angle brackets are firmly affixed to the facade and the flagpole is mounted in these fittings with quarter and half clamps. These clamps are then tightened to fix the flagpole in place. Both fittings and clamps are hot galvanised.
These clamps are then tightened to fix the flagpole in place. Both fittings and clamps are hot galvanised.
For flagpoles measuring 6,7 and 8 metres. Ideal for flagpoles intended for positioning on a site for an extended period before being moved. 
A PVC pipe is sunk or cast in the ground. The bottom section of the flagpole is cylindrical and can therefore slide into the ground sleeve, where it can be locked in place with a simple screw or two. The flagpole can then be taken down and moved as required.
A PVC pipe is sunk or cast in the ground. The bottom section of the flagpole is cylindrical and can therefore slide into the ground sleeve, where it can be locked in place with a simple screw or two. The flagpole can then be taken down and moved as required.